Canada

Other Sites in English

NX700 Software update for Bluetooth

New as of May 15, 2012

1.1. Download

Please download "Bluetooth.zip" file.

These files are zip-compressed, and you need to unzip them on your PC before copying to an SD card.

â– Bluetooth.zip (4.06MB)

When this file is unzipped, "blackbox" and "Bluetooth" folders are shown.

 

1.2. Copy folders to SD card

Please copy "backup", "blackbox" and "Bluetooth" folders to an empty SD card.

2.Update

1)Switch on the vehicle's ignition.

2)After the NX700 system starts, please insert the SD card to the NX700 after pushing "Map" key of Source screen.

1)Switch on the vehicle's ignition.
2)After the NX700 system starts, please insert the SD card to the NX700 after pushing

3)It will start to update after a few seconds.

3)It will start to update after a few seconds.

4)It will finish updating after about 2 minutes, and green check mark will be displayed.

5)System will re-boot automatically when you pull out the SD card from the NX700. And then please push reset button of NX700.

4)It will finish updating after about 2 minutes, and green check mark will be displayed.
5)System will re-boot automatically when you pull out the SD card from the NX700. And then please push reset button of NX700.

3.Confirm result

1)Select the Tel (Telephine) Source

2)Select "Setup"

3)Select "Info"

4)Confirm that the versin should be "2.00.17.30".

Cautions:

Updating re-starts from the beginning when you turn off and on the backup (continuous battery) line or push the reset button of NX700.

The information below still remain even after this update.

Sometimes Tel button of Source screen is invalid after you make a call and stop a call immediately from iPhone. In that case, please push reset button of NX700. In addition, please re-connect with iPhone after pushing reset button. (NX700 Mobile Phone Compatibility *48)

Sometimes you cannot continue calling after you stop the engine of car while you are calling or receiving a call. In that case, please push the reset button of NX700. In addition, please re-connect with iPhone after pushing reset button. (NX700 Mobile Phone Compatibility *49)

Return to the top of the page